American Audio CK-1000 MP3 Uživatelská příručka stáhnout pdf (Strana 30)

The crossfader is “Hot Swapable” which means it may be replaced at any time, even when power is

applied. Only replace with American Audio Part Feather Fader Plus. Replacing with any other model

fader may seriously damage your mixer.

Replacing the Crossfader:

1. Disconnect the mixers main power supply

2. Using a Phillips screw driver, unscrew the six stainless steel retainer screws that hold the mixer

face plate in place.

3. Gently remove the channel fader knobs and crossfader knob. Lift the mixer face plate from its to

access the crossfader. Carefully pull the crossfader up from its seated position.

4. After removing the crossfader, disconnect the ribbon cable that attaches the crossfader to the

PC board. Grasp the crossfader by its base and pull the ribbon cable by its connector not the

  

tors orientation.

5. Connect the new crossfader to the ribbon cable and replace in reverse order.

CROSSFADER REPLACEMENT

1 2 ... 25 26 27 28 29 30 31 32 33 34

Žádné komentáře

American Audio CK-1000 MP3 Uživatelská příručka Strana 30